Maytag MVWX655DW1 Parts Manual

The Maytag MVWX655DW1 is a high-efficiency top-load washing machine with PowerWash cycle, Deep Water Wash option, 4.7 cu. ft. capacity, stainless steel wash basket, 12 wash cycles, 10 wash temperatures, 5 spin speeds, and advanced vibration control. Below are key sections for parts identification, replacement procedures, technical specifications, maintenance, and troubleshooting.

Parts Overview

Key components: Wash basket, agitator, drive motor, transmission, water inlet valve, drain pump, control board, lid switch, suspension system.

Cabinet Components

Exterior and structural parts including cabinet, lid, control panel, and base.

1. Cabinet Assembly: Complete outer cabinet with powder coat finish
2. Lid Assembly: Glass lid with hinge and lock mechanism
3. Control Panel: User interface with cycle selection buttons
4. Base Assembly: Structural base with leveling legs
5. Back Panel: Rear access panel for service

WARNING! Cabinet is heavy; use proper lifting techniques. Ensure unit is unplugged before servicing.

Drive System Parts

Components responsible for wash basket movement and agitation.

1. Drive Motor: 1/2 HP direct drive motor with mounting bracket
2. Transmission: Gear reduction transmission with clutch
3. Drive Coupling: Flexible coupling between motor and transmission
4. Agitator Dogs: Drive dogs for agitator engagement
5. Basket Drive: Spline drive for wash basket rotation

CAUTION! Drive system contains high torque components; disconnect power before servicing.

Control System Components

• Main Control Board: W11035684 - Primary electronic controller
• User Interface: W11035688 - Control panel with display
• Temperature Sensors: W11035689 - Water temperature monitoring
• Pressure Switch: W11035690 - Water level detection
• Motor Control: W11035691 - Motor speed and direction control
• Lid Lock: W11035692 - Electronic lid locking mechanism

Water System Parts

Water inlet, distribution, and drainage components.

Inlet System: Hot/cold water valves, hoses, filters. Drain System: Pump, hoses, lint filter.

Water Inlet Valve: Dual solenoid hot/cold valve. Drain Pump: 1/8 HP centrifugal pump. Water Hoses: Reinforced rubber hoses. Lint Filter: Removable lint collection system. Water Level Pressure Tube: Water level sensing tube.

Technical Specifications

Capacity: 4.7 cubic feet. Power Requirements: 120V AC, 60Hz, 15A.

1. Disconnect power and water supply before parts replacement.
2. Refer to wiring diagram for electrical connections.
3. Use genuine Maytag replacement parts only.
4. Test operation after parts replacement.

Tip: Keep parts organized during disassembly for easier reassembly.

Replacement Procedures

Common parts replacement steps and procedures.

1. Drive Belt: Remove cabinet, loosen motor mount, replace belt.
2. Water Pump: Drain unit, disconnect hoses, remove mounting bolts.
3. Lid Switch: Remove control panel, disconnect wiring, replace switch.
4. Agitator: Remove cap, undo bolt, lift off agitator.
5. Motor: Disconnect wiring, remove mounting bolts, replace motor.
6. Suspension Springs: Support tub, compress spring, remove hooks.
7. Control Board: Remove console, disconnect all connectors, replace board.
8. Inlet Valve: Shut off water, disconnect hoses and wiring, replace valve.

WARNING! Always disconnect power before electrical work. Follow safety procedures.

Maintenance Parts

Regular maintenance components and replacement intervals.

Electrical Components

Wiring, connectors, and electrical safety parts.

CAUTION! Electrical components contain hazardous voltages. Qualified technicians only.

Troubleshooting Parts Guide

Service: 1-800-344-1274; www.maytag.com/parts