Maytag MVWB765FW Repair Manual

The Maytag MVWB765FW is a 4.3 cubic foot capacity top-load washing machine with stainless steel wash basket, 12 wash cycles, 5 wash/rinse temperature combinations, deep water wash option, and power wash cycle. This repair manual covers safety procedures, troubleshooting, disassembly instructions, and replacement procedures for common components. Below are key sections for safety, features, diagnosis, repair procedures, and maintenance.

Safety Precautions

Always disconnect power before servicing. Wear safety glasses and gloves.

Model Specifications

• Capacity: 4.3 cubic feet
• Dimensions: 27" W x 27" D x 43" H
• Voltage: 120V AC, 60Hz
• Current: 15 Amps
• Water Pressure: 20-120 psi
• Cycle Options: 12 wash cycles
• Temperature Settings: 5 combinations
• Basket Material: Stainless steel

Troubleshooting Guide

Common issues and diagnostic procedures.

1. Washer won't start: Check power, lid switch, timer
2. No water fill: Verify water supply, inlet valves
3. No spin: Inspect motor, belt, lid switch
4. Leaking: Check hoses, pump, tub seal
5. Noise: Examine motor bearings, pump, agitator

WARNING! Always disconnect power before troubleshooting electrical components.

Component Locations

Key components and their positions within the washer.

Disassembly Procedures

Step-by-step cabinet disassembly for component access.

1. Remove top panel: Insert putty knife at rear corners, release clips
2. Remove control panel: Remove screws, disconnect wiring harnesses
3. Remove front panel: Remove screws along sides and bottom
4. Remove back panel: Remove perimeter screws
5. Access internal components: Follow safety procedures

CAUTION! Label all wires and take photos during disassembly.

Motor Replacement

Procedure for replacing the drive motor.

1. Disconnect power and water supply
2. Remove cabinet panels for motor access
3. Disconnect motor wiring harness
4. Remove drive belt from motor pulley
5. Remove motor mounting bolts
6. Install new motor and reverse procedure
7. Test operation before reassembling cabinet

WARNING! Motor is heavy; use proper support during removal.

Pump Replacement

Steps for drain pump removal and installation.

1. Disconnect power and drain residual water
2. Tip washer back for pump access
3. Remove pump mounting hardware
4. Disconnect hoses and wiring
5. Install new pump with new clamps
6. Reconnect hoses and test for leaks

Tip: Have towels ready for water spillage during pump removal.

Lid Switch Replacement

Procedure for lid interlock switch replacement.

1. Remove top panel using putty knife method
2. Locate lid switch near hinge area
3. Disconnect wiring harness
4. Remove mounting screws
5. Install new switch and reassemble
6. Test lid safety function

CAUTION! Lid switch is a safety device; never bypass this component.

Timer Replacement

Control timer removal and installation steps.

1. Remove control panel screws
2. Carefully tilt panel forward
3. Label and disconnect all wiring harnesses
4. Remove timer mounting hardware
5. Install new timer and reconnect wires
6. Test all cycle functions

Note: Take photos of wire connections before disassembly.

Maintenance Schedule

Recommended maintenance intervals.

• Monthly: Clean detergent dispenser, inspect hoses
• Quarterly: Run cleaning cycle with washer cleaner
• Annually: Inspect drive belt, check for leaks
• Every 2 years: Replace inlet hoses
• As needed: Clean lint filter, check leveling

Error Codes

Reset: Unplug for 5 minutes to clear error codes.

Service: 1-800-344-1274; www.maytag.com